Excellent Fecral Wire , Spiral Heating Resistance Wire

Excellent Fecral Wire , Spiral Heating Resistance Wire
Chat Now
Product Details

specifications of spiral heating resistance wire :


Chemical Content(%)

Max 0.70Max 1.023.0~26.0Max 0.604.5~6.5Bal.-

Mechanical Properties of electric blankets heating wire

Max Continuous Service Temp1250ºC
Resisivity at 20ºC1.42±0.06 ohm mm2/m
Density7.10 g/cm3
Thermal Conductivity46.1KJ/m·h·ºC
Coefficient of Thermal Expansion16.0×10-6/ºC
Melting Point1500ºC
Tensile Strength637~784 Mpa
ElongationMin 12%
Section Variation Shrink Rate65~75%
Repeatedly Bend FrequencyMin 5 times
Continuous Service Time-
Micrographic StructureFerrite
Magnetic PropertyMagnetic

Furnace resistance alloy heating wire
1. A quite reasonable price
2. Stable performance:
3 high working temperature

Specification of heating pad wire :

We specializing in Ferro-Chrome (Fe-Cr-AL) wire, Nickel-Chrome (Nichrome) wire, Copper Nickel (Constantan) wire, Stainless steel wire and related products in alloys tailored to meet specific customer requirements.

Round wire from SWG 0 to SWG 48(Dia 0.04mm-8.0mm).

Ribbon/strip: Thickness: 0.04mm-0.75mm

Width: 0.08mm-6.0mm

Our furnace resistance alloy heating ribbon is of high quality with following features:
1. A quite reasonable price
2. Stable performance: High working temperature(The highest temperature can be 1400), high strength under temperature, corrosion resistance, long life-span, allowable high surface load, small specific gravity, good formability and weldability.

Delivery status and supply state of furnace resistance alloy heating ribbon

Wire and plate with the looseness or oxidation colour soft modal supply.

Strip except special requirements outside, general with after annealing oxidation colour supply.

The flat silk thread and protecting gas to light after annealing soft modal supply.

2, product packaging of furnace resistance alloy heating ribbon

Wire or strips to pack cloth bandaged volumes supply.

Thread and flat silk, axis encapsulate supply.

3, export products and users have special requirement, negotiation.


1, when the design should be based on the power wiring method, reasonable surface load, the correct choice of silk diameter,
2, before installation coping furnace thorough examination, cleared ferritic, "carbon, and the electric stove contact risks to avoid short circuit, in case caused furnace silk breakdown,
3, when installation should press design wiring method properly connected;
4, in use before should check the sensitivity of the temperature control system, in case of failure, cause temperature burn